Giatsu IKALA - Page 46

USER AND INSTALLATION MANUAL

44
MONOBLOCK IKALA
FUNCTIONS
The air conditioner can be controlled using the remote control. Two AAA batteries are required.
NOTE:Youwillndmoreinformationaboutthefunctionsonthenextpage.
POWER
Press “POWER” to turn the unit On or Off.
MODE
Press to change between the 4 different modes. The display will show the symbol for
the mode currently selected.
COOLING
The cooling function allows the air conditioner to cool the
room and at the same time reduces air humidity. The desired
temperature can be adjusted using the increase and decrease
button between 16°C and 30°C. The fan speed can also be
adjusted using the speed button.
DRY
Dry mode will extract moisture from the air, which will be drained
outside using the installed drain pipe. the fan speed cannot be
adjusted in dry mode.
FAN
In fan mode the appliance will recirculate the air within the
room, and will not cool, heat or dehumidify. The fan speed can
be adjusted using the Speed button, But the desired temperature
can not be set.
HEATING
The heating function allows the air conditioner to heat the room.
The desired temperature can be adjusted using the increase and
decrease button between 16°C and 30°C. The fan speed can also
be adjusted using the speed button.
FAN SPEED
SILENT
Silent mode can be activated from APP or the remote control, It
can also be activated by pressing " " + " " on unit control
panel at the same time. It will only operate in cooling or heating
modes, the fan speed will change to low and noise will be lower.
Press to change the fan speed between Low, Medium and High.
The fan speed cannot be adjusted in Dry or Silent modes.
TIMER
The air conditioner contains a 24 hour timer, which can be used to either set a delayed
start, or a set period of operation.
SHUTDOWN TIMER:
While the unit is running press the timer button, the display will ash “0” 5 times.
After the 5th ash, use the up and down buttons to adjust the duration in 1 hour
increments between 1 to 24 hours. When the timer has elapsed, the unit will shutdown
automatically.
DELAYED START TIMER:
With the unit in standby, press the timer button, the display will ash “0” 5 times. After
the 5th ash, use the up and down buttons to adjust the duration in 1 hour increments
between 1 to 24 hours. After the timer has elapsed, the unit will start up in the same
mode with the same settings as when it was turned off.
3. OPERATION