Robo-Tuner Test Step-by-Step
1. Enter the Red Bank, then rotate the Gear Shift knob to the G position.
2. Push down on the Digital Varitone knob.
3. The entire test takes a little under two minutes and steps through each Robo-Tuner at
increasing speeds. Sit back, look at the Gear Shift knob, and enjoy the light show.
4. When complete, return the silver tog-pot to its center position.
Bluetooth ID (Position = B, ID = B)
The pedals read the Bluetooth ID to enable wireless control with Firebird X. This function
provides the ID for reference during the Bluetooth “pairing” process, and requires no user
interaction. For more on pairing, see page 27.
Bluetooth Step-by-Step
1. Enter the Red Bank, then rotate the Gear Shift knob to the B position.
2. The four ID characters read sequentially in the middle of the Gear Shift knob (e.g., 0-9-
P-3).
3. To exit Bluetooth ID mode, return the silver tog-pot to its center position.
Piezo Calibration (Position = Arrow, ID = b# symbols)
The piezo calibration process analyzes the levels of each string’s individual piezo pickup,
which provides data to the Robo-Tuners for tuning. Optimizing the calibration may improve
tuning performance.
Piezo Calibration Step-by-Step
1. Enter the Red Bank, then rotate the Gear Shift knob to the Arrow position.
2. Push down on the Digital Varitone knob. All string LEDs will be lit red, except that the
low E will flash green to indicate this string will be calibrated first. The Gear Shift display
shows P (for “pick”).
3. Pick the string with the same force, pick, and pick angle you use during tuning. The Gear
Shift center shows the measured level, and after the string has decayed, shows P again.
4. Pick the string each time the P re-lights until the string's LED switches to solid green and
another string starts blinking green.
5. Pick the next string as you did in steps 3-5.
6. Repeat step 5 until all strings are calibrated. Return the silver tog-pot to its center
position.
Page 35
To Next Page
Loading...
