15 | P a g e
Advanced Hardware Functions ( Category)
Except for Calibration Mode, these Functions are for advanced users only.
Gibson recommends the default settings.
Calibration Mode
Note: You must recalibrate Gibson G FORCE if:
You change your strings’ gauge, type, or brand
Perform a master system reset
Encounter issues like erratic machine head movements, strings not tuning properly, etc.
Before calibration, tune the guitar to standard pitch (red tuning bank, E Function).
1. With Gibson G FORCE off, press the On button.
2. Strum the open strings once.
3. When all LEDs are green, all six strings are tuned. Gibson G FORCE turns off automatically (if any
LEDs aren’t green, pluck those strings individually).
Calibration:
1. Press On three times. Press the Left button once (selects ).
2. Press Enter twice. The string LEDs blink red.
3. Strum once. All lights should shine green briefly then turn off. If the LEDs continue to flash red,
mute the strings and strum again.
4. Once the strings have turned off from being green, or show a combination of blue and red LEDs,
mute the strings. Then all string LEDs blink red.
5. Repeat steps 3 and 4 until the LEDs light sequentially and one string LED is lit.
Accuracy
Balance tuning accuracy vs. speed
1. With Gibson G FORCE off, press On three times. Press the Left button to select . Press
Enter.
2. Again, press the Left button to select . Press Enter.
3. The Left/Right buttons select the accuracy. More lit LEDs = higher accuracy/tuning takes a little
longer. Fewer lit LEDs = accuracy is a little lower/faster tuning speed.
4. Press Enter = accuracy setting stored.
To Next Page
Loading...