Gibson G FORCE - Machine Head Delay; Machine Head Speed; Interference Filter

16 | P a g e
Machine Head Delay
Set a delay before the machine heads start turning after initiating a Function
1. With Gibson G FORCE off, press On three times. Press the Left button once to select .
Press Enter.
2. Press the Left button twice to select the string LED. Press Enter.
3. The Left/Right buttons select the delay. Each unlit LED increases delay by 0.5 seconds.
4. Press Enter = delay setting stored.
Machine Head Speed
Slow the machine head speed to accommodate guitars whose neck relief or
neck stability degrades tuning accuracy
1. With Gibson G FORCE off, press On three times. Press the Left button once to select .
Press Enter.
2. Press the Left button three times to select the string LED. Press Enter.
3. Use the Left/Right buttons to select the speed. Each unlit LED decreases the speed.
4. Press Enter = speed setting stored.
Interference Filter
Reduce interference among strings if a machine head turns for a string other
than the one you’re plucking.
1. With Gibson G FORCE off, press On three times. Press the Left button once to select .
Press Enter.
2. Press the Left button four times to select the string LED. Press Enter.
3. Use the Left/Right buttons to select the filtering amount. Each unlit LED increases the filtering
amount to reduce interference.
4. Press Enter = interference filter setting stored.
Note: Raising this setting to six lit LEDs may increase performance but make the e and B strings more
susceptible to incorrect tuning, even if G FORCE indicates they are in tune. If this occurs, lower the
Interference Filter setting to three or four lit LEDs.