3
E. .02.1999 • G. 04.04.24
2 Standard Specifications
Before installing the Giersch Series M10 oil burner, please check that al items included in the standard
specifications are present.
Standard specifications:
Burner, fixing unit, separate operating instructions, technical information leaflet, flange gasket, one 7-pin
and one 4-pin connector (Wieland connector).
Oil jets are not included
in the standard specifications.
3 Maintenance and Customer Service
The complete system should be checked once a year for correct functioning and leaks in accordance with
DIN 4755 by a representative of the manufacturer or other suitably qualified person.
According to EN 267, the repair of components with safety-related functions is not permitted. On the other
hand, parts may be replaced with genuine, equivalent – and where necessary tested – components.We
accept no liability for consequential damage in cases of incorrect installation or repair, the fitting of non-
genuine parts or where the equipment has been used for purposes for which it was not intended.
4 Operating Instructions
The Operating Instructions together with this Technical Information Leaflet must be displayed in a clearly
visible position in the boiler room. It is essential that the address of the nearest customer service centre is
written on the back page of the Operating Instructions.
5 Instruction of Operative Personnel
Faults are often caused by operator error. The operative personnel must be properly instructed in the func-
tion of the burner. In the event of recurring faults, Customer Service should be notified.
6 Key for code designation
Example:
hot air generators
air damper
start-up load reduction
2 stage
burner type
burner series
M10 -Z / AE-L-WLE
To Next Page
Loading...
