EasyManua.ls Logo

Giersch RG30 - User Manual

Giersch RG30
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Technical Information • Installation Instructions
Gas
Issued November 2007
Right reserved to effect technical changes
in the interest of product improvement !
RG20 / RG30
GB

Table of Contents

Questions and Answers

  • R
    Regina HarrellAug 17, 2025
    What to do if Giersch Indoor Fireplace burner starts then goes to fault mode?
    • N
      Nichole LeeAug 17, 2025
      If the Giersch Indoor Fireplace burner starts up but switches to fault mode, it could be due to several reasons. A possible cause is a leaking solenoid valve if there is an ionization message. Other potential issues include a gas solenoid valve that doesn't open, in which case you should replace the compact unit. If the starting gas quantity is set too low, increase it. Also, the gas nozzle might be dirty or faulty, requiring replacement.
  • B
    Barry BrownAug 23, 2025
    Why does the flame extinguish during operation in my Giersch RG30?
    • J
      Jamie RichardsAug 23, 2025
      If the flame extinguishes during operation of your Giersch Indoor Fireplace, ensure there is a sufficient gas supply. If not, safeguard the gas supply. Also, check the filter in the compact unit and clean or replace it if it's dirty.
  • D
    Daniel NicholsAug 29, 2025
    What to do if Giersch RG30 burner motor starts briefly then faults?
    • J
      Julia MackAug 30, 2025
      If the burner motor of your Giersch Indoor Fireplace starts up briefly and the control unit goes back to fault, it might be because the control unit has not been cleared of the fault. Clear the control units of the fault. Additionally, the air pressure switch might not be in the idle position, so check the air pressure switch.
  • S
    sarah97Sep 4, 2025
    Why does the control box reset automatically on my Giersch Indoor Fireplace?
    • M
      Michael BryanSep 4, 2025
      If the control box of your Giersch Indoor Fireplace resets automatically, it could be due to intermittent gas pressure fluctuations triggering the gas pressure monitor. To resolve this, safeguard the gas supply. If necessary, lower the starting point of the gas pressure monitor.
  • C
    Claire BrownNov 10, 2025
    How to troubleshoot a Giersch RG30 burner motor that won't start?
    • A
      ashleywatsonNov 10, 2025
      If the burner motor of your Giersch Indoor Fireplace doesn't start, several issues could be the cause. Check for a faulty electric supply lead and rectify any faults in the electrical installation. Examine the fuse and replace it if necessary. Ensure the safety thermostat is unlocked. If the temperature of the controller setting is exceeded, allow the temperature to drop before attempting a restart. Other potential causes include a faulty control box (replace it), a leak (rectify it), no gas supply (safeguard the gas supply), a faulty gas pressure monitor (replace the compact unit), a dirty filter in the compact unit (clean or replace it), a faulty burner motor (replace it), no load at terminal 5 (check the plug connection and current path of the solenoid valve), or a mains voltage less th...

Giersch RG30 Specifications

General IconGeneral
BrandGiersch
ModelRG30
CategoryIndoor Fireplace
LanguageEnglish