- 34 -8S651MP-RZ Series Motherboard
English
CMOS Setup Ut ility-Co pyright (C) 1984 -2004 Aw ard Soft ware
} Stan dard CM OS Feat ures
} Adva nced BI OS Feat ures
} Inte grated Periphe rals
} Powe r Manag ement S etup
} PnP/ PCI Con figurat ions
} PC H ealth St atus
} Frequ ency/Vol tage Con trol
Top Perform ance
Load Fail-Sa fe Defa ults
Load Optimiz ed Defa ults
Set Supervis or Pass word
Set U ser Pass word
Save & Exit S etup
Exit Without S aving
ESC: Quit higf: Selec t Item
F8: Q- Flash F10: Save & Exit S etup
Chan ge/Set/Di sable Pas sword
Set Supervisor/User Password
When you select this function, the following message will appear at the center of the screen to assist you
in creating a password.
Ty pe the passw ord, up to eight characters, and press <Enter>. You will be asked to confirm the
password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> w hen you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system w ill boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passw ords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all BIOS
Setup program function. When enabled, the Supervisor password is required for entering the BIOS
Setup program and having full configuration fields, the User password is required to access only basic
items.
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be prompted
for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted only
when you try to enter Setup.
Ente r Passw ord:
Load Optimized Defaults
CMOS Setup Ut ility-Co pyright (C) 1984 -2004 Aw ard Soft ware
} Stan dard CM OS Feat ures
} Adva nced BI OS Feat ures
} Inte grated Periphe rals
} Powe r Manag ement S etup
} PnP/ PCI Con figurat ions
} PC H ealth St atus
} Frequ ency/Vol tage Con trol
Top Perform ance
Load Fail-Sa fe Defa ults
Load Optimiz ed Defa ults
Set Supervis or Pass word
Set U ser Pass word
Save & Exit S etup
Exit Without S aving
ESC: Quit higf: Selec t Item
F8: Q- Flash F10: Save & Exit S etup
Load Optimiz ed Defa ults
Selecting this field loads the factory defaults for BIOS and Chipset Features which the system automatically
detects.
Load Optimiz ed Defau lts (Y/N )? N
To Next Page
Loading...
Need help?
General
