17
Hardware Installation Process
"*" For GA-6OXT-A only.
J) WOL (Wake On Lan)
+5V SB
GND
Signal
1
1
D/E) FDD/IDE1/IDE2 [Floppy Connector/IDE1 (Primary), IDE2(Secondary)
Connector]
IDE1
1
IDE2
1
C) LED1 (RAM LED)
¾ Important Notice:
Please connect first harddisk to IDE1 and
connect CDROM to IDE2.
¾ Do not remove memory modules while
RIMM LED is on. It might cause short or
other unexpected damages due to the
3.3V stand by voltage. Remove memory
modules only when STR function is
disabled by jumper and AC Power cord is
disconnected.
FDD
L) F_AUDIO (Front Audio)*
¾ If you want to use "Front Audio" connector, you
must move 3-4, 5-6 Jumper. In order to utilize the
front audio header, your chassis must have front
audio connector. Also please make sure the pin
assigment on the cable is the same as the pin
assigment on the MB header. To find out if the
chassis you are buying support front audio
connector, please contact your dealer.
2
7
8
MIC
GND
Rear Audio(R)
GND
Rear Audio(L)
Front Audio(R)
Front Audio (L)
1
To Next Page
Loading...
