Gigabyte GA-6OXT - Usb Controller; Init Display First

BIOS Setup
39


 IDE1 Conductor Cable
Auto Will be automatically detected by BIOS. (Default Value)
ATA66/100 Set IDE1 Conductor Cable to ATA66/100 (Please make sure your IDE device
and cable is compatible with ATA66/100).
ATA33 Set IDE1 Conductor Cable to ATA33 (Please make sure your IDE device and
cable is compatible with ATA33).


 IDE2 Conductor Cable
Auto Will be automatically detected by BIOS. (Default Value)
ATA66/100 Set IDE2 Conductor Cable to ATA66/100 (Please make sure your IDE device
and cable is compatible with ATA66/100).
ATA33 Set IDE2 Conductor Cable to ATA33 (Please make sure your IDE device and
cable is compatible with ATA33).


 USB Controller
Enabled Enable USB Controller. (Default value)
Disabled Disable USB Controller.


 USB Keyboard Support
Enabled Enable USB Keyboard Support.
Disabled Disable USB Keyboard Support. (Default value)


 USB Mouse Support
Enabled Enable USB Mouse Support.
Disabled Disable USB Mouse Support. (Default value)


 Init Display First
PCI Set Init Display First to PCI. (Default value)
AGP Set Init Display First to AGP.