- 34 -
GA-8INXP Motherboard
English
USB-CDROM Select your boot device priority by USB-CDROM.
USB-HDD Select your boot device priority by USB-HDD.
LAN Select your boot device priority by LAN.
Disabled Select your boot device priority by Disabled.
Boot Up Floppy Seek
During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is
40 tracks 720K, 1.2M and 1.44M are all 80 tracks.
Disabled BIOS will not search for the type of floppy disk drive by track number. Note
that there will not be any warning message if the drive installed is 360K.
(Default value)
Enabled BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note
that BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are
all 80 tracks.
CPU Hyper-Threading
#
Disabled Disable CPU Hyper Threading.
Enabled Enable CPU Hyper Threading Feature. Please note that this feature is only
working for operating system with multi processors mode supported.
(Default value)
Flexible AGP 8X
Auto Automatically set AGP transfer rate according to AGP compatibility and stability.
(Default value)
8X Always set AGP transfer rate to 8X if the 8X mode supported by the AGP card.
4X Set AGP transfer rate to 4X mode no matter what the AGP transfer rate the card is.
DRAM Data Integrity Mode
If you are using the Non-ECC DRAM, the mode will show "Non-ECC" and this function is disabled.
ECC Set DRAM mode at ECC.
Non-ECC Set DRAM mode at Non-ECC.
Init Display First
This feature allows you to select the first initiation of the monitor display from which card when you
install an AGP card and a PCI VGA card on board.
PCI Set initial display first to PCI slot.
Enabled Set initial display first to AGP. (Default value)
" # " System will detect automatically and show up when you install the Intel
®
Pentium
®
4 processor with HT Technology.
To Next Page
Loading...
Need help?
General
