- 38 -
GA-8INXP Motherboard
English
Onboard ATA/RAID Device
If you don't set any HDD Device in IDE3 or IDE4 but enable this function, the normal message
"MBUltra133(PDC20276) BIOS is not installed becasue there are no drives attached" will come out.
Ignore this message or set the option at Disabled to make the message disappear.
Enabled Enable Onboard ATA/RAID function. (Default Value)
Disabled Disable this function.
RAID Controller Function
RAID Set onborad RAID chip function a RAID.
ATA Set onborad RAID chip function a ATA. (Default Value)
Onboard H/W LAN
Disabled Disable onboard LAN function.
Enabled Enable Onboard LAN function. (Default Value)
Onboard LAN Boot ROM
This function decide whether to invoke the boot ROM of the onboard LAN chip.
Disabled Disable this function. (Default Value)
Enabled Enable this function.
Onboard Serial Port 1
Disabled Disable onboard Serial port 1.
3F8/IRQ4 Enable onboard Serial port 1 and address is 3F8, using IRQ4. (Default value)
2F8/IRQ3 Enable onboard Serial port 1 and address is 2F8, using IRQ3.
3E8/IRQ4 Enable onboard Serial port 1 and address is 3E8, using IRQ4.
2E8/IRQ3 Enable onboard Serial port 1 and address is 2E8, using IRQ3.
Auto BIOS will automatically setup the port 1 address.
Onboard Serial Port 2
Disabled Disable onboard Serial port 2.
3F8/IRQ4 Enable onboard Serial port 2 and address is 3F8, using IRQ4.
2F8/IRQ3 Enable onboard Serial port 2 and address is 2F8, using IRQ3. (Default value)
3E8/IRQ4 Enable onboard Serial port 2 and address is 3E8, using IRQ4.
2E8/IRQ3 Enable onboard Serial port 2 and address is 2E8, using IRQ3.
Auto BIOS will automatically setup the port 2 address.
To Next Page
Loading...
