- 47 -
BIOS Setup
English
Frequency/Voltage Control
Figure 8: Frequency/Voltage Control
CMOS Setup Utility-Copyright (C) 1984-2002 Award Software
Frequency/Voltage Control
CPU Clock Ratio [15X] Item Help
CPU Host Clock Control [Disabled] Menu Level X
x CPU Host Frequency (Mhz) 100
x PCI/AGP Frequency fixed 33/67
PCI/AGP Frequency (Mhz) 33/66
DIMM OverVoltage Control [Normal]
AGP OverVoltage Control [Normal]
AGP Voltage Control [Normal]
Normal CPU Vcore 1.475V
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F3: Language F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
CPU Clock Ratio
This option will not be shown or not be available if you are using a CPU with the locked ratio.
15X~21X It's depends on CPU Clock Ratio.
CPU Host Clock Control
Note: If system hangs up before enter CMOS setup utility, wait for 20 sec for times out reboot. When
times out occur, system will reset and run at CPU default Host clock at next boot.
Disabled Disable CPU Host Clock Control. (Default value)
Enabled Enable CPU Host Clock Control.
CPU Host Frequency (Mhz)
This item will be available when "CPU Host Clock Control" is set to Enabled.
100~200 Set CPU Host frequency from 100Mhz to 200Mhz.
*If you want DDR run in 200Mhz, the CPU Host Frequency have to set at 100Mhz.
*If you want DDR run in 266Mhz, the frequency have to set at 133Mhz.
Incorrect using it may cause your system broken. For power End-User use only!
To Next Page
Loading...
