Gigabyte GA-8INXP - Page 40

- 36 -
GA-8INXP Motherboard
English
On-Chip Primary PCI IDE
When Enabled, allows you to use the onboard primary PCI IDE. If a hard disk controller card is
used, set at Disabled.
Disabled Disable onboard 1st channel IDE port.
Enabled Enable onboard 1st channel IDE port. (Default value)
On-Chip Secondary PCI IDE
When Enabled, allows you to use the onboard primary PCI IDE. If a hard disk controller card is
used, set at Disabled.
Disabled Disable onboard 2nd channel IDE port.
Enabled Enable onboard 2nd channel IDE port. (Default value)
IDE1 Conductor Cable
Auto Will be automatically detected by BIOS. (Default Value)
ATA66/100 Set IDE1 Conductor Cable to ATA66/100 (Please make sure your IDE device
and cable is compatible with ATA66/100).
ATA33 Set IDE1 Conductor Cable to ATA33 (Please make sure your IDE device
and cable is compatible with ATA33).
IDE2 Conductor Cable
Auto Will be automatically detected by BIOS. (Default Value)
ATA66/100 Set IDE2 Conductor Cable to ATA66/100 (Please make sure your IDE device
and cable is compatible with ATA66/100).
ATA33 Set IDE2 Conductor Cable to ATA33 (Please make sure your IDE device
and cable is compatible with ATA33).
USB 1.1 Controller
Disable this function if you are not using onboard USB feature.
Enabled Enable USB Controller. (Default value)
Disabled Disable USB Controller.
USB 2.0 Controller
Disable this function if you are not using onboard USB 2.0 feature.
Enabled Enable USB 2.0 Controller. (Default value)
Disabled Disable USB 2.0 Controller.