- 28 -
& First/Second/Third Boot Device
Speciesthebootorderfromtheavailabledevices.Usetheupordownarrowkeytoselectadeviceand
press <Enter> to accept. Options are: LS120, Hard Disk, CDROM, ZIP, USB-FDD, USB-ZIP, USB-CDROM,
USB-HDD, Legacy LAN, Disabled.
& Password Check
Specieswhetherapasswordisrequiredeverytimethesystemboots,oronlywhenyouenterBIOSSetup.
Afterconguringthisitem,setthepassword(s)undertheSet Supervisor/User Password item in the BIOS
Main Menu.
Setup A password is only required for entering the BIOS Setup program. (Default)
System A password is required for booting the system and for entering the BIOS Setup program.
& HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your hard
drive. This feature allows your system to report read/write errors of the hard drive and to issue warnings
when a third party hardware monitor utility is installed. (Default: Disabled)
& Away Mode
Enables or disables Away Mode in Windows XP Media Center operating system.
Away Mode allows the system to silently perform unattended tasks while in a low-power mode that appears
off. (Default: Disabled)
& Full Screen LOGO Show
Allows you to determine whether to display the GIGABYTE Logo at system startup. Disabled displays
normal POST message. (Default: Enabled)
& Init Display First
Speciestherstinitiationofthe monitor displayfromtheinstalledPCIgraphicscard or theonboard
graphics.
PCI Slot SetsthegraphicscardonthePCISlotastherstdisplay. (Default)
Onboard Setstheonboardgraphicsastherstdisplay.
2-6 Integrated Peripherals
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Integrated Peripherals
OnChip SATA Controller [Enabled]
OnChip SATA Type [Native IDE]
x OnChip SATA Port as ESP Press Enter
Onboard LAN Function [Enabled]
Onboard LAN Boot ROM [Disabled]
` SMART LAN [Press Enter]
Onboard Audio Function [Enabled]
USB Controllers [Enabled]
USB Legacy Function [Enabled]
USB Storage Function [Enabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Parallel Port [378/IRQ7]
Parallel Port Mode [SPP]
x ECP Mode Use DMA 3
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level `