Gigabyte GA-E240N - Standard CMOS Features

- 26 -
& Date (mm:dd:yy)
Sets the system date.
& Time (hh:mm:ss)
Sets the system time.
& IDE Channel 0, 1 Master/Slave
IDE HDD Auto-Detection
Press <Enter> to autodetect the parameters of the SATA device on this channel.
IDE Channel 0, 1 Master/Slave
CongureyourSTAdevicesbyusingoneofthetwomethodsbelow:
• Auto Lets the BIOS automatically detect SATA devices during the POST. (Default)
• None If no SATA devices are used, set this item to None so the system will skip the detection
of the device during the POST for faster system startup.
Access Mode Sets the hard drive access mode. Options are: Auto (default), CHS, LBA, Large.
Thefollowingeldsdisplayyourharddrivespecications.Ifyouwishtoentertheparametersmanually,
refer to the information on the hard drive.
Capacity Approximate capacity of the currently installed hard drive.
& Halt On
Allows you to determine whether the system will stop for an error during the POST.
Options are: "All Errors," "No Errors," "All, But Keyboard". (Default)
& Memory
Theseeldsareread-onlyandaredeterminedbytheBIOSPOST.
2-4 Standard CMOS Features
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Standard CMOS Features
Date (mm:dd:yy) Tue, Jul 10 2012
Time (hh:mm:ss) 22:31:24
` IDE Channel 0 Master [None]
` IDE Channel 0 Slave [None]
` IDE Channel 1 Master [None]
` IDE Channel 1 Slave [None]
Halt On [All, But Keyboard]
Base Memory 640K
Extended Memory 1662M
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level `