Gigabyte GA-E240N - Onchip Sata Controller

- 29 -
& OnChip SATA Controller
Enables or disables the integrated SATA controllers. (Default: Enabled)
& OnChip SATA Type
 CongurestheoperatingmodeoftheintegratedSATAcontroller.
Native IDE Allows the SATA controllers to operate in Native IDE mode. Enabled Native IDE mode
if you wish to install operating systems that support Native mode. (Default)
AHCI   CongurestheSATAcontrollertoAHCImode.Advanced Host Controller Interface
(AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
Serial ATA features such as Native Command Queuing and hot plug.
& OnChip SATA Port as ESP
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
OnChip SATA Port as ESP
Port0 as ESP [Disabled]
Port1 as ESP [Disabled]
Port2 as ESP [Disabled]
Port3 as ESP [Disabled]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level ``
& Port0 as ESP/Port1 as ESP/Port2 as ESP/Port3 as ESP
 ThisoptioniscongurableonlywhenOnChip SATA Type is set to AHCI. Enabled will speed up the hot
plug detection of the connected SATA device. (Default: Disabled)
& Onboard LAN Function
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default:
Disabled)
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN cable.
This feature will detect cabling issue and report the approximate distance to the fault or short.
& SMART LAN (LAN Cable Diagnostic Function)
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
SMART LAN
Start detecting at Port.....
Part1-2 Status = Open / Length = 0m
Part3-6 Status = Open / Length = 0m
Part4-5 Status = Open / Length = 0m
Part7-8 Status = Open / Length = 0m
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level ``