Gigabyte GA-K8N Pro - Page 28

- 28 -GA-K8N Pro Motherboard
English
Silicon Image Sil3512 chip supports Serial ATA
connectors hot plug function.
9) IDE3 / IDE4 (RAID/ATA133, Green Connector)
Important Notice: The red stripe of the ribbon cable must be the same side with the Pin1. If you wish
to use IDE3 and IDE4, please use it in unity with BIOS (either RAID or ATA133). Then, install the
correct driver to have proper operation. For details, please refer to the GigaRAID manual.
10) SATA0_SII / SATA1_SII (Serial ATA Connector)
You can connect the Serial ATA device to this connector, it provides you high speed transfer rates
(150MB/sec). If you wish to use RAID function, please use it in unity with BIOS and install the
correct driver to have proper operation. For details, please refer to the SATA RAID manual.
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
SATA0_SII
1
139
240
IDE4
IDE3
7
SATA1_SII
17
K8n pro_1001_q.p65 2003/8/18, ¤U¤È 06:0628