Gigabyte GA-WRX80-SU8-IPMI - 1-5 Back Panel Connectors

1-5 Back Panel Connectors
D-Sub Port
The D-Sub port supports a 15-pin D-Sub connector and supports a maximum resolution of 1920x1200@60 Hz
(the actual resolutions supported depend on the monitor being used). Connect a monitor that supports
D-Sub connection to this port.
COM Port
Use this port to connect devices such as a mouse, modem or other peripherals.
USB 3.2 Gen 2 Type-A Port (Red)
The USB 3.2 Gen 2 Type-A port supports the USB 3.2 Gen 2 specication and is compatible to the USB
3.2 Gen 1 and USB 2.0 specication. Use this port for USB devices.
USB Type-C
®
Port
The reversible USB port supports the USB 3.2 Gen 2x2 specication and is compatible to the USB 3.2
Gen 2, USB 3.2 Gen 1, and USB 2.0 specications. Use this port for USB devices.
GbE LAN Port (LAN1~2)
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
• When removing the cable connected to a back panel connector, rst remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
Link LEDActivity LED
LAN Port
LED State Description
Link (Right)
Solid Green 100 Mbps data rate
Solid Amber 1 Gbps data rate
Activity (Left) Blinking Yellow Active
Link LEDActivity LED
10 GbE LAN Port
The Gigabit Ethernet LAN port provides Internet connection at up to 10 Gbps data rate. The following
describes the states of the LAN port LEDs.
LED State Description
Link (Right)
Solid Amber 10 Gbps data rate
Solid Green 1 Gbps data rate
Activity (Left) Blinking Yellow Active
Activity LEDLink LED
- 13 -