Gigabyte GA-WRX80-SU8-IPMI - Page 36

` System Event Log
Press [Enter] to change the SEL event log conguration.
& SEL Components
Enables or disables the event logging for error/progress codes during boot. (Default: Enabled)
& Erase SEL
Chooses options for erasing SEL. Options are: No (default), Yes, On next reset, Yes, On every reset.
& When SEL is Full
Chooses options reactions to a full SEL. Options are: Do nothing (default), Erase Immediately, Delete
Oldest Record.
& Log EFI Status Codes
Enables or disables the logging of EFI Status Codes. Options are: Disabled, Both, Error code (default),
Progress code.
` View FRU information
This page displays the basic system ID information, as well as system product information. Items on this
page are non-congurable.
` Bmc self test log
Logs the report returned by BMC self test command.
& Erase Log
Selects the options for ease log. Options are: Yes, On every reset (default), No.
& When log if full
Selects the action to be taken when log is full. Options are: Clear Log (default), Do not log any more.
` BMCnetworkconguration
Press [Enter] to congure BMC network parameters.
& CongurationAddresssource
Selects to congure LAN channel parameters statically or dynamically (by BIOS or BMC). Unspecied
will not modify any BMC network parameters during BIOS phase. Options are: Unspecied (default),
Static, DynamicBmcDhcp, DynamicBmcNonDhcp.
& Station IP address
Enters IP Address. This item is available when CongurationAddresssource is set to Static.
& Subnet mask
Enters Subnet mask. This item is available when CongurationAddresssource is set to Static.
& Router IP address
Enters Router IP address. This item is available when CongurationAddresssource is set to Static.
& Router MAC address
Enters Router MAC address. This item is available when CongurationAddresssource is set to
Static.
& IPv6 Support
Enables or disables IPv6 support. (Default: Enabled)
& CongurationAddresssource
Selects to congure LAN channel parameters statically or dynamically (by BIOS or BMC). Unspecied
will not modify any BMC network parameters during BIOS phase. Options are: Unspecied (default),
Static, DynamicBmcDhcp.
& Station IPv6 address
Enters IPv6 Address. This item is available when CongurationAddresssource is set to Static.
- 36 -