- 14 -
Hardware Installation
1-4-2 Installing and Removing a Memory Module
• Before installing a memory module, make sure to turn off the computer and unplug the power
cord from the power outlet to prevent damage to the memory module.
• To avoid any potential short circuit of the DIMM slots, please remove any stand-offs from the
chassis that will be located underneath the DIMM slots, before installing the motherboard into the
chassis.
• Be sure to install DDR5 DIMMs on this motherboard.
1
2
2
Follow these instructions to install a DIMM module:
1. Insert the DIMM memory module vertically into the DIMM slot and push it down.
2. Close the plastic clip at both edges of the DIMM slots to lock the DIMM module.
3. Reverse the installation steps when you want to remove the DIMM module.
Memory Type DDR5
Voltage (V) 5V
Connector UDIMM ECC/Non-ECC
Speed (MT/s) 5200 3600
Channels 1,2
DIMM Per Channel 1,2
DIMM Capacity (GB) 2,4,8,16,32
Note:
• When only one DIMM is used, it must be populated in memory slot A1.
To Next Page
Loading...
Need help?
General
