Gigabyte R282-Z93 - Page 13

- 13 - Hardware Installation
Expansion Slot
Riser Card CRS2014:
 1 x PCIe x16 slot (Gen4 x16), FHFL
Riser Card CRS2026:
 2 x PCIe x16 slot (Gen4 x16), FHFL
Riser Card CRS2026:
 2 x PCIe x16 slot (Gen4 x16), FHFL
1 x OCP 3.0 mezzanine slot with PCIe Gen4 x16 bandwidth from CPU_0
Supported NCSI function
1 x OCP 2.0 mezzanine slot with PCIe Gen3 x8 bandwidth (Type1, P1, P2)
Supported NCSI function
1 x M.2 slot:
-M-key
-PCIe Gen3 x4
-Supports NGFF-2242/2260/2280/22110 cards
-CPU TDP is limited to 225W if using M.2 device
NOTE: Support is not provided for mixed GPU populations
Storage
 12 x 3.5" SATA/SAS hot-swappable HDD/SSD bays from onboard SATA
ports
 2.5" HDD/SSD supported
 Default conguration supports:
 12 x SATA drives
or
 4 x SATA drives
 8 x SAS drives via SAS HBA
NOTE: SAS card is required to support SAS devices.
Internal I/O
 1 x M.2 slot
 1 x USB 3.0 header
 1 x COM header
 1 x TPM header
 1 x Front panel header
 1 x HDD back plane board header
 1 x PMBus connector
 1 x IPMB connector
 1 x Clear CMOS jumper
 1 x BIOS recovery jumper