Gigabyte R282-Z93 - Page 98

BIOS Setup - 98 -
Parameter Description
USB Conguration Options
Press [Enter] for more options.

XHCI Controller0 Enable
– Enable or disable USB3 controller.
– Options available: Enabled/Disabled/Auto. Default setting is Auto.

XHCI Controller1 Enable
– Enable or disable USB3 controller.
– Options available: Enabled/Disabled/Auto. Default setting is Auto.

USB ecc SMI Enable
– Options available: Enabled/Off/Auto. Default setting is Auto.

MCM USB enable
– Press [Enter] for advanced congurations.
SD Dump Options
Press [Enter] for more options.

SD Conguration Mode
– Select SD Mode.
– Options available: SD Dump disabled/SD Dump Enabled. Default
setting is SD Dump disabled.
AC Power Loss Options
Press [Enter] for more options.

AC Loss Control
– Select AC Loss Control Method.
– Options available: Power Off/Power On/Last State. Default setting
is Last State.
I2C Conguration Options
Press [Enter] for more options.

I2C 0/1/2/3/4/5 Enable
– Enable or disable I2C 0/1/2/3/4/5.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart Conguration Options
Press [Enter] for more options.

Uart 0 Enable
– Uart 0 has no HW FC if Uart 2 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

Uart 1 Enable
– Uart 1 has no HW FC if Uart 3 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

Uart 2 Enable (no HW FC)
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

Uart 3 Enable (no HW FC)
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
ESPI Conguration Options
Press [Enter] for more options.

ESPI Enable
– Options available: Disabled/Enabled/Auto. Default setting is Auto.