Gigabyte R282-Z93 - Page 99

- 99 - BIOS Setup
Parameter Description
eMMC Options
Press [Enter] for more options.

eMMC/SD Congure
– Options available: Disabled/SD Normal Speed/SD High Speed/SD
UHSI-SDR50/SD UHSI-DDR50/SDUHSI-SDR104/eMMC Emmc
Backward Compatibility/eMMC High Speed SDR/eMMC High
Speed DDR/eMMC HS200/eMMCHS400/eMMC HS300/Auto.
Default setting is Auto.

Driver Type
– BIOS will select MS driver for SD selections.
– Options available: AMD eMMC Driver/MS Driver/Auto. Default
setting is Auto.

D3 Cold Support
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

eMMC Boot
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
FCH RAS Options
Press [Enter] for more options.

ALink RAS Support
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

Reset after sync ood
– Enable AB to forward downstream sync-ood message to system
controller.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.