GigaDevice Semiconductor GD-Link Adapter - Figure 3-9. GD-Link Adapter Update Firmware Situation 1 Figure 2; Figure 3-10. GD-Link Adapter Update Firmware Situation 1 Figure 3

22 pages

Save Page as PDF

To Next Page

To Previous Page

GD-Link Adapter User Guide

Figure 3-9. GD-Link adapter update firmware situation 1 figure 2

3. There are two steps in the upgrade process. In step1, GD-Link LED3 is always bright. In

step2, GD-Link LED2 is always bright. The prompt interface is shown in Figure 3-10. GD-

Link adapter update firmware situation 1 figure 3 and Figure 3-11. GD-Link adapter

update firmware situation 1 figure 4.

Note: Please do not disconnect the GD-Link from the computer during the upgrade process.

Figure 3-10. GD-Link adapter update firmware situation 1 figure 3

Main Page

Table of Contents2
List of Figures3
List of Tables4
Introduction5
Interactive Mode and Hardware Connection5
Buttons and LED5
Figure 2-1. GD-Link Adapter Hardware5
Connecting GD-Link Adapter with Target Board6
Offline Programming6
Tool Download6
Update User Code6
Figure 2-2. Schematic Diagram of GD-Link Adapter6
Figure 3-1. GD-Link Adapter Offline Download Configuration7
Figure 3-2. Choose the GD MCU Model7
Figure 3-3. Load the bin File8
Figure 3-4. Fill in the Address8
Figure 3-5. Configure Option Byte9
Figure 3-6. Updata bin File9
Update Firmware10
Update Prompt Type 110
Figure 3-7. GD-Link Adapter Update File Finished10
Figure 3-8. GD-Link Adapter Update Firmware Situation 1 Figure 110
Figure 3-9. GD-Link Adapter Update Firmware Situation 1 Figure 211
Figure 3-10. GD-Link Adapter Update Firmware Situation 1 Figure 311
Figure 3-11. GD-Link Adapter Update Firmware Situation 1 Figure 412
Figure 3-12. GD-Link Adapter Update Firmware Situation 1 Figure 512
Update Prompt Type 213
Figure 3-13. GD-Link Adapter Update Firmware Situation 1 Figure 613
Figure 3-14. GD-Link Adapter Update Firmware Situation 2 Figure 113
Figure 3-15. GD-Link Adapter Update Firmware Situation 2 Figure 214
Figure 3-16. GD-Link Adapter Update Firmware Situation 2 Figure 314
Auto-Load Signal Introduction15
Figure 3-17. Schematic Diagram of GD-Link Auto Load Signals15
Programming in IDE16
In Keil (Version 5.26 Above) for Programming16
Figure 4-1. Debug Settings in Keil16
Figure 4-2. JTAG/SWD Port Selection in Keil17
In IAR (Version 8.32 Above) for Programming18
Figure 4-3. Flash Programming Algorithm Selection in Keil18
Figure 4-4. Project Options in IAR19
Figure 4-5. Debugger Settings in IAR20
Figure 4-6. Interface Selection in IAR20
Revision History21

GigaDevice Semiconductor GD-Link Adapter - Figure 3-9. GD-Link Adapter Update Firmware Situation 1 Figure 2; Figure 3-10. GD-Link Adapter Update Firmware Situation 1 Figure 3

Table of Contents

Related product manuals