37
Sending SMS (text messages)
Gigaset C300-C300A/CS310-CS310A / GBR / A31008-M2223-L101-4-7619 / sms_BRD_neutral.fm / 13.09.2012
Version 4, 16.09.2005
Setting SMS centres
SMS messages are exchanged between SMS
service centres operated by service provid-
ers. You must enter the SMS service centre
through which you wish to send and receive
SMS messages into your phone. You can
receive SMS messages from every SMS serv-
ice centre that is entered, provided you have
registered with your service provider.
Your SMS messages are sent via the SMS cen-
tre that is entered as the active send service
centre (¢ page 37). Only one SMS service
centre can be the active send service centre
at any one time.
If no SMS service centre is entered, the
SMS menu only consists of the entry Service
Centres. Enter an SMS service centre
(¢ page 37).
Entering/changing SMS service
centres
¤ Find out about the services and special
functions offered by your service pro-
vider before you make a new applica-
tion and/or before you delete pre-config-
ured numbers.
§Menu§ ¤ SMS ¤ Service Centres
s Select SMS service centre (e.g.,
SMS centre # 1) and press
§OK§.
You have the following options:
Active Send Srvc. Cent.
If SMS messages are to be sent via this
SMS centre, press
§OK§ to activate the SMS
centre (
³ = on). If a different SMS centre
was active previously, then this will be
deactivated.
SMS centre #
Enter the number of the SMS centre and
press
§OK§.
Sending an SMS via another SMS
service centre
¤ Activate the SMS centre (2 or 3) as the
active send service centre.
¤ Send the SMS.
Receiving SMS messages on
aPABX
u You can only receive an SMS when Call-
ing Line Identification is forwarded
to the extension of the PABX (CLIP).
The CLIP evaluation of the SMS centre
number is completed in your Gigaset.
u Depending on your PABX, you may have
to add the access code (external line pre-
fix) before the number of the SMS centre.
If in doubt, test your PABX, e.g., by send-
ing an SMS to your own number: once
with and once without the access code.
u When you send SMS messages, your
sender number may be sent without your
extension number. In this case, the recip-
ient cannot reply to you directly.
Sending and receiving SMS messages on
ISDN PABXs is only possible via the MSN
number assigned to your base.
Activating/deactivating SMS
function
If you deactivate the SMS function, you can-
not send or receive any SMS messages with
your phone.
The settings you have made for sending and
receiving SMS messages (e.g., the numbers
of the SMS service centres) and the entries in
the incoming and outgoing lists are saved
even after deactivation.
§Menu§ Open main menu.
*#Q5#23
Enter the digits.
Q
§OK§ Deactivate the SMS function.
Or:
§OK§ Activate the SMS function
(default setting).
To Next Page
Loading...
