53
Base station settings
Gigaset C300-C300A/CS310-CS310A / GBR / A31008-M2223-L101-4-7619 / registr_sett.fm / 13.09.2012
Version 4, 16.09.2005
Activating repeater support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
§Menu§ ¤ Settings ¤ System
¤ Repeater Mode
Press
§OK§ to activate/deactivate repeater
mode (
³ = activated).
After activating or deactivating the
repeater, switch your handset off and
on again (¢ page 20).
Protecting against
unauthorised access
Protect the system settings of the base
station with a PIN known only to yourself.
The system PIN must be entered when,
for example, registering/de-registering a
handset to/from the base or when restoring
the default settings.
Changing the system PIN
You can change the 4-digit system PIN set on
the base (default setting: 0000) to a 4-digit
PIN known only by you.
Gigaset C300A/CS310A: Setting a system PIN
enables remote operation of the answering
machine (¢ page 43).
§Menu§ ¤ Settings ¤ System ¤ System PIN
~ Enter the current system PIN
and press §OK§.
~ Enter your new system PIN and
press
§OK§.
Resetting the system PIN
If you have forgotten your system PIN, you
can reset the base to the original code 0000:
Disconnect the power cable from the base.
Hold down the registration/paging key on
the base while reconnecting the power
cable to the base. Hold down the key for at
least 5 seconds.
The base has now been reset and the system
PIN set to 0000.
Resetting the base to the
default settings
When the settings are restored:
u Date and time are retained
u Handsets are still registered
u Eco Mode is activated and Eco Mode+ is
deactivated
u The system PIN is not reset
§Menu§ ¤ Settings ¤ System ¤ Base Reset
§Yes§ Press the display key.
Please note
u Eco Mode / Eco Mode+ (¢ page 45)
and repeater support cancel each
other out, i.e., you cannot use Eco
Mode and Eco Mode+ when using a
repeater.
u The default encrypted transmission
setting is deactivated when a
repeater is activated.
Please note
All handsets are de-registered and must
be re-registered. All settings are reset to
the default settings.
Please note
The answering machine is ready for use
approx. 15 seconds after the base has
been connected or reset.
To Next Page
Loading...
