52
Gigaset E310/E310A / Great Britain / A31008-M2301-L101-1-7619 / appendix.fm / 26.07.2011
Version 5, 03.04.2011
Questions and answers
If you have any questions about the
use of your phone, you can contact
us at www.gigaset.com/service
for assistance 24/7.
In addition, the following table pro-
vides troubleshooting assistance.
The display is blank.
1.
The handset is not activated.
¤ Press and hold the end call
key a.
2.
The battery is empty.
¤ Charge or replace the battery
(¢ page 13).
"Base" flashes in the display.
1.
The handset is outside the range
of the base.
¤ Move the handset closer to the
base.
2.
The range of the base is reduced
because Eco Mode mode is acti-
vated.
¤ Deactivate Eco Mode
(¢ page 40) or reduce the dis-
tance between the handset
and base.
3.
The base is not activated.
¤ Check the base power adapter
(¢ page 11).
"Put into base" or "Register HS"
flashes in the display.
The handset has not been regis-
tered with the base or has been de-
registered.
¤ Place the handset in the base
(automatic registration, may take
up to 5 minutes) or register the
handset manually (¢ page 41).
The handset does not ring.
The ringer melody is deactivated.
¤ Activate the ringer melody
(¢ page 47).
You cannot hear a ringer/dialling
tone from the fixed line.
The phone cord supplied has not
been used or has been replaced by
a new cord with the wrong pin con-
nections.
¤ Please always use the phone cord
supplied or ensure that the pin
connections are correct when
purchasing from a retailer
(¢ page 59).
The connection always terminates
after approx. 30 seconds.
Repeater activated/deactivated
(¢ page 48).
¤ Activate/deactivate the handset
(¢ page 20).
When you try to activate Eco
Mode+, "Not possible!" appears in
the display.
A handset is registered to the base
that does not support Eco Mode+.
Error tone sounds after system PIN
prompt.
You have entered the wrong system
PIN.
¤ Reset the system PIN to 0000
(¢ page 49).
Forgotten system PIN.
¤ Reset the system PIN to 0000
(¢ page 49).
To Next Page
Loading...
