Gigaset E370 / LUG_NF BE-NL en / A31008-M2815-M201-1-3F19 / starting_NF.fm / 11/23/18
Template Module, Version 1.2, 11.09.2018
Handset
9
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries
Charging the batteries
¤ Charge the batteries fully prior to first use in the
charging cradle.
The batteries are fully charged when the power icon
disappears from the display.
Only use rechargeable batteries, as this could otherwise result in significant health
risks and personal injury. For example,
the outer casing of the batteries could be
destroyed or the batteries could explode. The device could also malfunction or be
dama
ged as a result of using batteries that are not of the recommended type.
¤ Insert the batteries
(for correct +/- direction,
se
e diagram).
¤ Fit the battery cover from
the top.
¤ Press the cover until it
clicks into place.
To re-open the battery cover:
¤ Insert a fingernail behind
the notch at the top of the
cover and slide it
downwards.
Batteries may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Handsets contained in the package have already been registered to the base. In the
ev
ent that a handset is not registered however (indicated by Please register handset),
register the handset manually (
page 48).
To Next Page
Loading...
