9. Screen Calibrate
Click "Carlibrate" to call up the dialog box as Fig.7-13
Fig. 7-13
Click "Yes" to enter the calibration interface as Fig.7-14.
Fig. 7-14
Please operate according to the prompt. If calibration is successful, the prompt "Calibrate OK!"
will appear. If failed, "Calibrate fail, please again"will appear.
7.4 Sample Setting
The interface is shown as Fig.7-15.
Fig. 7-15
【Function introduction】
Sample settings include AC filter, EMG filter, DFT, Demo and Pace mode.
【Operating instructions】
To Next Page
Loading...
