The operation is same as system setting.
Filter setting can be performed by clicking
on the screen.
7.5 Print Setting
The interface is shown as Fig.7-16 and7-17.
Fig. 7-16
Fig. 7-17
【Function introduction】
Print setting, prepared for print, includes print mode, auto strip, gain set, speed set, report print
set (QRS-temp, case information, parameters, conclusion)
【Operating instructions】
1. Print mode
1x12, 1x12+1, 2x6, 2x6+1, 3x4, manual, store modes including. The operating instruction of
each mode is shown as following:
1x12+1、2x6+1: rhythm lead print, rhythm lead can be set in analyse setting.
1x12、2x6、3x4: automatical print
Manual: in manual mode you can print waveform according to your need without save.
To Next Page
Loading...
Need help?
General
