11
OPERATION
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with
sideshields when operating tools. Failure to do so
could result in objects being thrown into your eyes,
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not rec-
ommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when not
in use or carrying at your side.
WARNING:
Do not use Sure-Grip™ on free hanging light fixtures.
Only use on sockets and fixtures that are fixed in place.
REMOVING/INSTALLING LIGHT BULB
See Figure 7-9
Push the power button on the motor drive to turn on
the drive. The green activation light should light up.
Slide the ON/OFF switch on the Sure-Grip™ system to
the ON ( I ) position. The Sure-Grip™ system will briefly
vibrate when turned on.
NOTE: The power light on the Sure-Grip™ system should
be green. When the battery in the Sure-Grip™ system is
low, the power light will change from green to red. Change
the battery immediately. Refer to Changing the Batteries
later in this manual.
ADJUSTING SURE-GRIP™ FOR USE
See Figure 10.
Turn motor drive pivot knob counterclockwise.
Pivot motor drive head to desired angle.
Turn pivot knob clockwise to lock into position.
POWER BUTTON
ON/OFF
SWITCH
POWER LIGHT
LIGHT
BULB
SUCTION HEAD
ACTIVATION
LIGHT
PIVOT KNOB
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Giraffe_SureGrip_OPManualFINAL.qxd 8/8/2006 6:49 PM Page 11
To Next Page
Loading...
