Bravo pH Monitoring System 10 User Guide
chapter.fm 3/21/16 4:05 pm
5.5 x 7.75 inches (140 mm x 197 mm)
•
Fully recharge the battery before each study (see Charging the Recorder on
page 10).
•
Clean the recorder after each study (see Cleaning the Recorder on page 29).
Charging the Recorder
The recorder is delivered with the battery fully discharged. It must be recharged before
using. A fully discharged recorder battery may take up to 7 hours to charge.
•
Connect the recorder to the charger and plug it into an electrical outlet, or
•
Connect the recorder to a USB cable and connect it to your PC. Do not use this
method for charging more than one recorder simultaneously.
Turning the Recorder On and Off
1. Press and hold the on/off button (see Description on page 7) for 5 seconds until the
recorder screen turns on.
The recorder automatically performs an internal diagnostic check, which includes
checking the batteries and verifying the time and date.
• The recorder screen displays a brief welcome message showing the software and
hardware versions.
• If the battery is sufficiently charged and the time and date are available, the main
menu is displayed.
• If the date or time is not available, the recorder automatically displays the screen
to set the date and time.
• If the main battery is low, the recorder displays:
Charge battery!
2. To turn off the recorder, press and hold the on/off button for 2–3 seconds until
Turn
OFF the Recorder?
appears on the recorder screen.
Note
The cursor’s default position shows the next logical step in your
workflow. For example, if you have completed calibration, the cursor
appears at Start Study. (You can move the cursor to select something
else.)
Note
The backlight remains on during Settings and Calibration processes.
When recording or the main screen is displayed, the backlight turns off
after the predefined time (default 30 seconds; see Choosing Study
Settings on page 11). Press any key to turn it back on. If you are not
sure if the recorder is turned on, press the on/off button once.
To Next Page
Loading...