Given Imaging Bravo - Performing a Bravo pH Study - Patient Instructions; Reviewing Instructions with Patients

Bravo pH Monitoring System 12 User Guide
chapter.fm 3/21/16 4:05 pm
5.5 x 7.75 inches (140 mm x 197 mm)
c. Press Enter . You move on to the first screen of the next setting: Show pH
value of Preferences .
4. The Preferences screen allows you to define setting that affect all studies.
• Show pH Value: If Yes , the current pH value appears on the recorder screen
during studies. If No , pH values are only displayed for the first 30 minutes of a
study. The factory default is No .
• Button Beep: If Yes , the recorder beeps when the patient presses a symptom
button. The factory default is Yes .
• Capsule LED Blink: If Yes , the recorder capsule LED blinks when the capsule
signals are received. The factory default is Yes .
• Set Date/Time: Once set, the recorder maintains the correct date and time. You
should only have to change this again if there is a time change (for example,
going on or off of Daylight Savings), or if the recorder battery is allowed to fully
discharge.
• Date Format: You can set the date format to MM-DD-YY or DD-MM-YY . The
factory default is MM-DD-YY .
• Time Format: You can set the time format to 12-hour (AM/PM) or 24-hour
(military) . The factory default is 12-hour .
• PC Software: Select the software used to record, view, and analyze the data
from studies. The choices are AccuView (factory default applies to Reflux
software, as well) and RAPID pH .
• Language: Select the language for the recorder interface. The choices are
English, Danish, Dutch, Finnish, French, German, Italian, Norwegian,
Portuguese, Spanish, and Swedish. The factory default is English .
• Backlight Duration: Set the time that the recorder screen backlight stays on
after a button is pressed. The choices are 15, 30 (factory default), 45, or 60
seconds.
5. To return one level up in the menu tree, press ESC .
֠
Note
At any time you may select Settings from the Main screen and
access Preferences to review and set the parameters.
֠
Note
Once you have set preferences, you will not need to reset them
unless:
• you want to change something, or
• the recorder battery is fully discharged.