How to turn the Communicator OFF: or to stop it dialling out.
From the Communicator: Press 1 2 3 4 ESC – Communicator will show OFF on the display. This will also stop
calls being sent out after it has been triggered.
From a Telephone: Quick guide: Call the Communicator and press 1 2 3 4 > *
1. Call the Communicator (telephone number of the SIM card that has been installed). You will hear a
long “beep” to indicate that the Communicator has answered. The Communicator’s display will read
“Call in”.
2. Press 1 2 3 4 (4 digit code) followed by the * key. You will hear 4 beeps to indicate that the
Communicator has been turned off and the Communicator will automatically hang up.
From a Text Message: Quick guide: Text the Communicator with 1 2 3 4 >* then press the return key.
Text the communicator (telephone number of the SIM card that has been installed) with the
message 1 2 3 4 * - ensure you then press the return key before pressing send so the cursor on your
phone is flashing on the next line. The Communicator’s display will briefly show a number, being
the number of texts is has received to date.
HOW TO STOP THE COMMUNICATOR DIALLING THE TELEPHONE NUMBERS IN SEQUENCE;
Quick guide: When the phone is answered, Press <#> or <*> on the receiving end’s telephone keypad to stop
the dialling sequence.
When the Communicator starts dialling, it will dial the first telephone number and repeat the pre-recorded
voice message three times. The number dialled will appear briefly on the display and the display will then
show the Telephone Number, in sequence, being called. If there is no response or acknowledgement (# or *
pressed) from that number, then it will dial the next number until all the programmed numbers for that trigger
are dialled. If there is no acknowledgement from any of the phone numbers, it will display “NO ANSWER”.
To stop this dial sequence, press the <*> key on the telephone keypad that is receiving the call. At that time,
the Communicator will stop its dialling sequence and the alarm (if programmed) will stop. If the local alarm
has been programmed as active, then pressing the <#> key will stop the dialling sequence, but the alarm will
continue to sound until timed out. In both cases, the Communicator will remain ON, waiting for any further
trigger.
You can also stop the dial sequence at the Communicator’s keypad by entering the 4 digit code and pressing
ESC. This will turn the Communicator OFF.
HOW TO OPEN “LISTEN-IN”
When answering a Voice Message from the Communicator: Quick guide: Press 9
1. If you wish to open “Listen-In” at any time, whilst receiving a voice message from the Communicator,
press 9 on your telephone keypad.
2. To close the “Listen-In”, simply hang up.
Page 10
To Next Page
Loading...