GJD GJD710 - Turning Communicator On;Off; Turn Communicator ON

1. Key in the four digit user Password code (Factory Default 1234).
2. Press PROGRAM > 8 > ENTER > 2 > ENTER
Display will show Output Type
Press 1 to program Output 1, Press 2 to program Output 2, etc.
Display will show Output Type
User
Press 1 to select Output as activating on Trigger 1 (if selected, Output 1 will then activate on activation of
Trigger 1, Repeat to program Output 2 activating on Trigger 2, etc.). Press 0 to return to User Activation only.
Press ENTER to save your selection.
HOW TO TURN THE COMMUNICATOR ON/OFF LOCALLY OR REMOTELY
How to turn the Communicator ON: (Default ON. That means the Communicator will always be active or ON
when power is first applied or re-applied to it. Turn OFF to program and then turn back ON and leave ON)
From the Communicator: Quick guide: Press 1 2 3 4 > ENTER
1. Check that the voice message and at least one phone number has been programmed into the
Communicator.
2. Press 1 2 3 4 ENTER. The Communicator will show “ON” on the display.
3. The triggers will become active after the delay time you have set has expired (Default 0 seconds or
instant).
From a Telephone: Quick guide: Call the Communicator and Press 1 2 3 4 > #
1. Check that the voice message and at least one phone number has been programmed into the
Communicator.
2. Call the Communicator (telephone number of the SIM card that has been installed). You will hear a
long “beep” to indicate that the Communicator has answered. The Communicator’s display will read
“Call in”.
3. Press 1 2 3 4 (4 digit code) followed by the # key. You will hear 2 beeps to indicate that the
Communicator has been turned on and the Communicator will automatically hang up.
4. The triggers will become active after the delay you have set up has expired (default set at 0 seconds,
instant).
From a Text Message: Quick guide: Text the Communicator with 1 2 3 4 ># then press the return key
1. Check that the voice message and at least one phone number has been programmed into the
Communicator.
2. Text the Communicator (telephone number of the SIM card that has been installed) with the
message: 1 2 3 4 # - ensure you then press the return key before pressing send so the cursor on your
phone is flashing on the next line. The Communicator’s display will briefly show a number, being the
number of texts it has received to date.
3. The triggers will become active after the time you have set has expired (default set at 0 seconds,
instant).
Page 9