1. First you have to download firmware to your computer. You can download
the firmware here. For GL-AR300M, GL-AR300M-Ext, GL-AR750S-Ext,
please download the .img firmware file. For GL-B1300, GL-S1300, please
download the .img firmware. Everyone else, download the .bin firmware file.
2. Connect your computer to the Ethernet port (either LAN or WAN) of the
router. You MUST leave the other port unconnected.
3. Press and hold the Reset button firmly first, and then power on your device.
(If your device does not have a power button, plugging it in will power it on
automatically.)
If you can not find the reset button, please refer to our page, How to Repair
and Reset.
Release your finger when you see the LED has flashed:
4. The Power LED will light up. Then, other LEDs will start flashing.
5.
• 6 times for GL-MiFi, and then the LTE light will faintly flash twice.
• 5 times for GL-AR150, GL-AR300M, GL-USB150, GL-AR750, GL-
AR750S-Ext (Slate), GL-X750-Ext (Spitz), GL-MT300N-V2, GL-E750
(Mudi).
• 4 times for GL-S1300, GL-B1300.
The leftmost LED may stay on the whole time while the rightmost LED
flashes 4 times, then the middle LED turns on and stays on.
(For some old GL-B1300, the leftmost LED stays on the whole time, and
both the middle LED and the rightmost LED flash 5 times at the same
time then they stay on.)
• 3 times for GL-MT300N, GL-MT300A.
• No repeat LED flashes signal for GL-MV1000.
(Power and WAN LEDs will stay on the whole time.)
6. Set your computer’s IP address to 192.168.1.2. Please check the step-by-
step guide for different operating systems below:
Windows 7 / Windows 10Mac
To Next Page
Loading...
Need help?
General
