Global Contract Compile - Tackboards; Load Bar

•Page globalcontract.com 14
• Summer 2017
GLOBALContract
INSTALLATION GUIDELINES
Tackboards
STEP 1: Slide universal brackets, with connection plate and screws attached, into
grooves on each side of panel.
STEP 2: Securely attach all screws using a #4 ALLEN BIT, or TORX T25 HEAD BIT.
STEP 3: Hang tackboard hooks, into notches on universal bracket.
Load Bar
STEP 1: Attach universal brackets, with connection plate and screws attached,
into groove on back of Load Bar.
STEP 2: Attach end caps to both sides, to secure the Load Bar to the universal
brackets.
STEP 3: Slide Load Bar with bracket assembly into grooves on sides of panels.
STEP 4: Position Load Bar into desired position, using a level.
STEP 5: Securely attach all screws using a #4 ALLEN BIT, or TORX T25 HEAD BIT.
1
1
2
2
3
3
4
5
6