Page • globalcontract.com17
• Summer 2017
GLOBALContract
Module Replacement
Applies to: fabric or laminate replacement. Conversion from glass to fabric, or
fabric to glass.
STEP 1: Remove the square #1 screws along the vertical part of the panel frame.
*DO NOT remove the Philllips screws found at the bottom!
STEP 2: Carefully remove the piece without causing ant damage.
STEP 3: If replacing a fabric module, remove the screws on the other side of the
panel, then slide the fabric module out.
*Steps 4 and 5 are for glass modules. If replacing fabric, skip to step 6.
STEP 4: Slide the glass out.
STEP 5: Carefully pry the glass frame off using a pick or a screwdriver.
*avoid damaging the panel components!
STEP 6: Slide the new fabric module in.
STEP 7: Carefully reattach the vertical part of the panel frame and gently close any
visible gaps between the pieces.
STEP 8: Reinstall all the screws and check for any gaps around the panel frame.
Reinstall all the screws and check for any gaps around the panel frame.
STEP 9: If the new screws were shipped along with the new fabric module, install
them as well.
INSTALLATION GUIDELINES
To Next Page
Loading...