Page 8
Installation and Proper Grounding
THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE OUTLET TO WHICH
THIS PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS NOT THE
PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD GROUND PRONG FROM THE POWER CORD OR USE ANY ADAPTER
PLUG (Fig. 8-1 and Fig. 8-2).
8. Make sure warning labels are properly positioned and legible and the instruction manual is available near
the slicer. Place the Spanish labels on the slicer if your work force requires them.
9. Complete the warranty card and mail to Globe or register online at www.globeslicers.com/warranty.asp.
10. Clean the slicer using the procedures outlined in the cleaning section (pages 13 through 15) prior to using the
slicer.
11. Contact your local representative or Globe directly if you have any questions or problems with the installation
or operation of this slicer.
Figure 8-1 Correct
Figure 8-2 Incorrect
To Next Page
Loading...
