Globe 3600P - Installation and Proper Grounding

Page 7
Installation and Proper Grounding
UNPACKING:
1. Unpack the slicer immediately after receipt. If the machine is found to be damaged, save the packaging
material and contact the carrier within fteen (15) days of delivery. Immediately contact your source of the
equipment. You have no recourse for damage after fteen (15) days.
2. With the slicer you should receive Globe oil, a warranty card, wall chart, and an instruction manual. Contact
Globe or your local supplier if you did not receive all of these items.
TO AVOID SERIOUS PERSONAL INJURY PROPERLY
INSTALL SLICER IN ADEQUATE WORK AREA
• ALWAYS install equipment in a work area with adequate light and space.
• ONLY operate the slicer on a solid, level, nonskid surface that is nonammable.
• NEVER bypass, alter, or modify this equipment in any way from its original condition. Doing so may create
hazards and will void the warranty.
• NEVER operate slicer without knife cover and knife ring guard securely installed.
• NEVER operate without all warning labels attached and the Globe wall chart posted.
INSTALLATION:
1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation and
operation if you have any questions or do not understand anything in the manual. Contact your local
representative or Globe rst.
2. Remove the slicer from the corrugated box.
NEVER USE SLICER WITHOUT RUBBER FEET INSTALLED.
3. Select a location for the slicer that has a level, solid, nonskid surface that is nonammable and is in a
well-lighted work area away from children and visitors.
USE AT LEAST TWO PEOPLE TO LIFT SLICER UP TO OPERATING LOCATION. NEVER ATTEMPT
TO LIFT SLICER ALONE.
4. Make sure the slicer is level. If the slicer wobbles/rocks once it has been placed on the table or counter,
adjust the rubber feet until the slicer is level.
5. Post Globe’s wall chart in a location within easy view of operator.
6. Inspect slicer to ensure all parts have been provided.
7. Make sure knife cover, knife ring guard and knife sharpener cover are in place.