Globe SP10 - Troubleshooting

Page17
Problem Possible Causes Action Required
Mixerwillnotrun. Bowlguardnotinclosedposition. Rotateguardtotherightuntilfullyclosed.
 Bowlnotraised. Raisebowltohighestposition.

 Timerisnotengaged. Turntimeratleastveminutespast“0”,thento 
  desiredtimeorsettimetothegreen“on”position.
 Powernotconnectedproperly. Checkallpowerconnections.Plugintoalivesocket.
  (Do not use extension cord!) Testsocketwith 
  anotheritem.
 Buildingcircuitbreakerisoff. Checkbreakerbox.
 Internaloverloadtripped. SP25&smallermodels:Pressstopbutton,then 
  pressresetbutton.Largermodels:Waittwo 
  minutes.Pressstopbuttonthenpressstartbutton.
  (If overload continues to trip, reduce batch size
and/or adjust recipe!)
Gearnotengaged. Switchgearfullyintoposition.(Mixer will not operate
if the speed control lever is positioned in between
speeds)
Mixerstopsduring Internaloverloadtripped. SP25&smallermodels:Pressstopbuttonthen
mixing.  pressresetbutton.Largermodels:Waittwo 
  minutes.Pressstopbuttonthenpressstartbutton.
  (If overload continues to trip, reduce batch size
and/or adjust recipe!)
 Damagedorbrokentransmissionbelt. SP25&largermodels:Contactatechnicianto 
  replacebelt.
 Speedswerechangedduringmixing, Returnspeedcontrollevertoaspeedmodel 
 SP80PLonly. positionandrestartthemixer.
Mixerisnoisy. Mixerisnotinstalledonlevelsurface. Adjustsurfaceorrelocatemixer.Makesurerubber
  feetareinstalled.
 Bowlnotseatedcorrectlyorclamps Ensurebowlisseatedintobowlcradlecorrectlyand
 notinplace. bowlclampsarelockedintoplace.

 Agitatornotttedproperly. Removeandattachagitatorintopositionproperly.
 Overloadingbowl. Reducebatchsize.(See Capacity Chart, page 16)
 Damagedorwornbelt. Replacebelt.
 Planetaryringgearneeds Contactatechniciantoinspectforsourceofnoise.
  moregrease.Reapplyhigh-pressuregrease.

Safetyguardseized Clean&lubricateslidesheath. Technicianmustdropdownplanetaryassemblyto
(willnotmovefreely).  accessmat&sheath.Contacttechnician.
Agitatorswon’tgo Lackoflubricationand/orcleaning Wipeplanetaryshaftwithacleandampclothand
ontotheplanetary oftheplanetaryshaft. lubricatetheshaftwithmineraloilorfoodquality
shafteasily.  grease.
Troubleshooting