EasyManuals Logo

Globe SP62P-4 User Manual

Globe SP62P-4
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Page6
Installation
UNPACKING
Unpackthemixerimmediatelyafterreceipt.Ifthemachineisfoundtobedamaged,savethepackagingmaterial
andcontactthecarrierwithinfteen(15)daysofdelivery.Immediatelycontactyoursourceoftheequipment.
You have no recourse for damage after fteen (15) days.
TO AVOID SERIOUS PERSONAL INJURY:
• ALWAYSinstallequipmentinworkareawithadequatelightandspace.
• ONLYoperatethemixeronasolid,LEVEL,non-skidsurfacethatisnonammable.
• NEVERbypass,alter,ormodifythisequipmentinanywayfromitsoriginalcondition.Doingsomaycreate
hazardsandwillvoidthewarranty.
• NEVERoperatethemixerwithoutallwarningsattachedtoit.
• DO NOTattempttoliftthemixeralone.
INSTALLATION
1. Readthismanualthoroughlybeforeinstallationandoperation.DONOTproceedwithinstallationand
operationifyouhaveanyquestionsordonotunderstandanythinginthismanual.Contactyourlocal
representativeorGloberst.
2. Removethecorrugatedboxfromtheskidbyremovingthebandsonthebox.NOTE:TheSP62PandSP80PL
areshippedinawoodencrate;onlytheboltsatthebottomofthecrate(allfoursides)needtoberemoved.
3. Carefullyunboltthemixerfromtheskidusingan11/16”or3/4”wrench.
4. Selectalocationforthemixerkeepingthesepointsinmind:
• Floororcountermustbelevel.
• Easyaccessformaintenanceandservice.
• Clearanceforoperatingcontrols,installingandremovingagitators,bowl,orattachments.
• Sufcientspaceforaddingingredientsduringmixingperiods.
• Ensurerearventilationoutletofmixerisnotblocked.
5. Useatleasttwootherpeopletotilttheunitandinstalltherubberfeet.
6. AboltdowntemplateandboltsareavailablefortheSP10,SP20,orSP25.ContactGlobeifneeded.
7. Inspectthemixertoensureallpartshavebeenprovided(i.e.bowl,beater,whip,anddoughhook).TheSP62P
onlyhasabowl,doughhook,andbowltruck.
8. Readtheelectricalinformationfoundonthedataplatelocatedattherearofthemachine.Theincoming
powershouldmatchtheratingonthedataplate.
CONNECTING TO ELECTRICAL POWER
Cord Connected Units: This machine is provided with a three-prong grounding plug. The outlet that
this plug is connected to must be properly grounded. If the receptacle is not the proper grounding type,
contact an electrician. Do not under any circumstances cut or remove the third ground prong from the
power cord or use any adapter plug. Never use an extension cord. Low amp supply could damage the
mixer or cause a re.

Other manuals for Globe SP62P-4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Globe SP62P-4 and is the answer not in the manual?

Globe SP62P-4 Specifications

General IconGeneral
BrandGlobe
ModelSP62P-4
CategoryMixer
LanguageEnglish

Related product manuals