0020085232_01 - 03/10 - Saunier Duval0020085232_01 - 03/10 - Protherm0020085232_01 - 03/10 - Hermann0020085232_01 - 03/10 - Glow-worm0020085232_01 - 03/10 - Bulex0020085232_01 - 03/10 - AWB
- 13 -
BESOIN D’AIDE ?¿NECESITA ASISTENCIA TÉCNICA?BISOGNO DI ASSISTENZA?ANY ASSISTANCE ?ANY ASSISTANCE ?POTREBUJETE POMOC?BISOGNO DI ASSISTENZA?ANY ASSISTANCE ?BESOIN D’AIDE ?HULP NODIG ?
BENÖTIGEN SIE TECHNISCHEN SUPPORT?
HULP NODIG ?
The
appliance
stops
working
Electrical circuit
interrupted
Check that there is no power cut and that the appliance is
correctly connected. When electrical power comes back
on, the appliance automatically comes back into service.
If the fault persists, contact your Installation/Servicing
company or Glow-worm Service.
Fault
Press on the "reset" button. Wait for 5 seconds. If the fault
persists and the symbol
appears, contact your
Installation/Servicing company or Glow-worm Service.
Lack of water in the
installation
(< 0.5 bars)
Open the lling tap located under the appliance until
you obtain a pressure of between 0.8 and 1.2 bars on
the indicator, refer to diagram overleaf. If relling needs
to be carried out too often, there may be a leak in your
installation. In this case, contact your Installation/Servicing
company or Glow-worm Service, to have your system
checked.
Excess water in the
installation
With central heating off, open the vent (bleed screw) on a
radiator to allow water to escape and reduce the pressure
in the heating circuit, or contact your Installation/Servicing
company or Glow-worm Service.
xx
Fault
Contact your Installation/Servicing company or Glow-
worm Service.
To Next Page
Loading...
Need help?
General
