GLP Impression Series - Mounting on the Floor (Upright); Mounting in hanging Position (Head first)

GLP  German Light Products GmbH instruction version 1.05 7
1x M10
(length max.16mm)
2x Camlock
quick release
fasteners
front side of the fixture
2.1.1 Mounting on the Floor (Upright)
To operate the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N in an upright position, please use the
dedicated tripod which is mounted to the bottom side of the system. It is
fixed with fasteners called Camlock quick-release connectors. Turn the
two fasteners both 90° to lock them. Do the opposite to release them
again. On both sides you'll find eyelets to pull though a fixing strap. This
allows an additional bracing of the system during the upright operation.
2x Camlock
2x eyelets
2.1.2 Mounting in hanging Position (Head first)
To operate the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N in an hanging position, please use a half-
coupler (clamp) which is mounted directly to the bottom side of the
system. It is fixed centrically with a M10x16 mm thread bolt.