6
Before Starting
Intended Use
Gmate™ system is intended for self-testing to monitor glucose
concentrations in fresh whole blood. Gmate™ system is for use
outside body(in vitro diagnostic use) in fingertips, forearm, upper
arm, hand, thigh and calf testing.
Test principle
The Gmate™ system is based on measurement of a small electrical
current produced by the reaction of glucose in the blood sample with
the reagents on the strip. This current changes with the amount of
glucose in the blood sample. The glucose concentration in the
sample is calculated based on the electrical current and displayed on
the meter.
Setting the time and date
Your Gmate™ meter comes with the time, date, year and unit of
measure pre-set. Before using your meter for the first time or if you
change the meter battery, you should check and set the time and
date. If you does not set your meter for the first time or after changing
the battery, you can hear beep 3 times when inserting a test strip.
See the 27 page(Setting the Meter) to ensure your desired settings
are saved.
To Next Page
Loading...
