42 Infotainment System
Headphones
A. Battery cover
B. Channel 1 or 2 switch
C. On/Off button
D. Volume control
E. Power indicator light
RSE includes two 2-channel
wireless headphones. Channel 1 is
dedicated to the DVD player, and
Channel 2 is dedicated to any
external auxiliary device connected
to the A/V jacks. The headphones
are used to listen to various multi‐
media. The wireless headphones
have an On/Off button (C), channel
1/2 switch (B), and a volume
control (D). Turn the headphones off
when not in use.
Push the On/Off button (C) to turn
on the headphones. A power
indicator light (E) on the
headphones comes on. If the
light (E) does not come on, check
the batteries. Intermittent sound or
static can also indicate weak
batteries. See “Battery
Replacement” later in this
section for more information.
Infrared transmitters are on the top
of the left seatback video screen.
The headphones shut off
automatically to save the battery
power if the RSE system is shut off
or if the headphones are out of
range of the transmitters for more
than three minutes. Moving too far
forward or stepping out of the
vehicle, can cause the headphones
to lose the signal or have static.
The headphones automatically
turn off after four hours of
continuous use.
To adjust the volume on the
headphones, use the volume
control (D).
For optimal audio performance, the
headphones must be worn correctly.
Headphones should be worn with
the headband over the top of the
head for best audio reception.
The symbol L (Left) appears on the
outside bottom edge of the left ear
cup and should be positioned on
the left ear. The symbol R (Right)
appears on the outside bottom edge
of the right ear cup and should be
positioned on the right ear.
Notice: Do not store the
headphones in heat or direct
sunlight. This could damage the
headphones and repairs will not
be covered by the warranty.
Storage in extreme cold can
weaken the batteries. Keep the
headphones stored in a cool,
dry place.
To Next Page
Loading...
