GME CM1039 - Scan Nuisance Delete; Dynamic Regrouping

20

Ifadifferentzoneisselectedwhilezonescanisactive,thenzonescancontinuestobeactive
intheselectedzoneifpossible.Iftherearenotenoughchannelstaggedforzonescaninthe
selectedzone,thenzonescanstops.
IftheSCANkeyispressedwhileascangroupisselected(i.e.:anRSSIvotingchannel),the
radiostopsthescangroupactivityandcommencesthezonescan.WhentheSCANkeyis
pressedagain,thezonescanstopsandtheradiowillresumescangroupactivity.
Duringzonescan,thedisplaychangesthroughthezonescanchannels.Whenactivityis
detectedonachannel,theradioholdsonthechannelandthedisplayshowsthenameof
theholdchannel.
Thecurrentchannelmaybeincludedinthezonescanchannellistevenifitisnottagged.
SCANNUISANCEDELETE
Anuisancechannelisonewheretemporaryunwantednoiseorinterferenceconstantly
stopsthescan.AnuisancechannelcanbetemporarilyremovedbyturningtheSELknob
whileholdingonthechannel.Theradiowillresumescanningandthenuisancechannelwill
beremovedforafixedtime(typically2minutes).
AnuisancechannelcanalsoberemovedfromthescansequencebyalongpresoftheSCAN
keywhileholdingonthechannel.Theradiowillresumescanningandthenuisancechannel 
willberemovedaslongaszonescanisactive.
DYNAMICREGROUPING
Dynamicregroupingallowsthenetworkordispatchertore‐assigntheradiotoaspecial
communicationstalkgroup.Whenoperatingonthisgroup,normalchannelchange
operationmaybedisabled.
DynamicregroupingisonlyavailableonP25trunkingchannels.
Toactivatedynamicregrouping,theoperatorsendsa‘DynamicRegroupRequest’tothe
P25network.
TosendaDynamicRegrouprequest:
1. PresstheSELknobtoaccessthemenu.
2. RotatetheSELknobtoselect‘TRUNKING’thenpresstheSELknob.
3. RotatetheSELknobtoselect‘DYNREGROUP’thenpresstheSELknobtosendthe
request.
4. Thedisplaywillshow‘SENDREQ’.

Iftherequestissuccessfulthedisplayshowsanacknowledgement.Therequestmaynot
succeedforvariousreasons.