go-e Gemini flex - Scope of Delivery; Included Items and Accessories

1818 1919
Starting the charging process
Connect the go-e Charger and the vehicle by using a
type 2 charging cable (or if the car has a type one so-
cket by using a type 2 to type 1 adapter cable). Make
sure that the type 2 plug is inserted as far as possible
into the type 2 socket of the charger.
The Charger is ready for charging and is waiting for
the car to release it. The LEDs light up yellow in the
number of the preset charging current.
Charging
After the car has enabled charging, the LEDs rotate
clockwise around the type 2 socket during the char-
ging process.
The number of „tails“ corresponds to the number of
connected phases or the number of phases set in the
app:
• 1 rotating tail = 1-phase charging (230 V)
• 3 rotating tails = 3-phase charging (400 V)
The speed of rotation and length of the tails indicate
the amount of charging current.
4.
5.
9. Commissioning/charging
3.
2.
Ready to charge
The go-e Charger is ready for operation. The number
of blue LEDs corresponds to the set charging current.
Five predened charging levels can be selected via
the but ton.
You can adjust the charging levels individually
in the go-e Charger app („Current levels“). It does not
matter whether the go-e Charger is connected single-
phase or three-phase.
1 LED = 1 A
Gemini ex 11 kW = 6 A - 16 A
Gemini ex 22 kW = 6 A - 32 A
1.
Start of the charger
The go-e Charger performs a self-test during initial
start-up or after a restart, during which the LEDs light
up in rainbow colou
rs.
9. Commissioning/charging
Plugging in the charger
Connect the go-e Charger Gemini ex directly to a red
CEE socket or to a suitable socket using an original go-e
adap ter.
Gemini ex 11 kW = 16 A
Gemini ex 22 kW = 32 A
Installation and operating manual go-e Charger Gemini ex V 1.4Installation and operating manual go-e Charger Gemini ex V 1.4