go-e Gemini flex - Important Symbols; Sustainable Charging

66 77
Installation and operating manual go-e Charger Gemini ex V 1.4Installation and operating manual go-e Charger Gemini ex V 1.4
Depending on the country, the require-
ments of the authorities and electricity
grid operators have to be observed, such
as a registration or approval requirement
for charging stations, or the limitation of
single-phase charging.
Please contact your electricity grid opera-
tor to nd out whether the go-e Charger
is subject to registration or approval and
whether other restrictions must be obser-
ved.
Registration information
Observe all safety regulations and
instructions in this manual!
Read the manual and the data sheet care-
fully and keep them for future reference.
The documents are intended to help you:
• To use the product safely and properly
• Increase the durability and reliability
• To avoid damage to the device or
property
• To prevent a threat to life and limb
Note before installation and
commissioning
Download the data sheet:
www.go-e.com
Instructions and downloads
3. Before installation and commissioning 4. Safety regulations/notes
General safety regulations
The go-e Charger may only be
used for charging battery electric
vehicles (BEV) and plug-in hybrids
(PHEV) with the adapters and cables inten-
ded for this purpose.
Disregarding the safety regulations can
have serious consequences. go-e GmbH
declines any liability for damage caused
by disregarding the operating instructions,
safety regulations or warnings on the unit.
High voltage - danger to life! Never use the
go-e Charger if the housing is damaged or
open.
In case of unusual heat development, do
not touch the go-e Charger, the charging
cable or adapter and stop the charging
process as soon as possible. If the plastic
is discoloured or deformed, contact custo-
mer support.
Never cover the go-e Charger during char-
ging. Heat build-up can lead to re.
Persons wearing electronic implants
should keep at least 60 cm away from
the go-e Charger due to electromagnetic
elds.
The go-e Charger Gemini ex has the com-
munication interfaces WiFi 802.11b/g/n
2.4GHz and RFID. WiFi is operated on a
frequency of 2.4Ghz, channels 1-13 with
the frequency band 2412-2472Mhz. The
maximum transmission power of the WiFi
is 20dBm. RFID is operated on a frequen-
cy of 13.56MHz with a maximum radiated
power of 60dBμA/m at 10m.
Any information regarding elec-
trical installation is intended ex-
clusively for a qualied electrician
whose training allows all electrical
work to be carried out in accor-
dance with the applicable national regu-
lations.
Before carrying out electrical connection
work, you need to de-energise the circuit.
Installation must be carried out in accor-
dance with local, regional and national re-
gulations.
Observe the permissible ambient condi-
tions from the data sheet. A location wit-
hout direct sunlight is recommended.
The Charger is only suitable for charging
gassing vehicle traction batteries in well-
ventilated rooms.
The unit must not be operated indoors if
there is an increased danger from ammo-
nia gases.
The Charger should not be operated in
the immediate vicinity of ammable or ex-
plosive substances, running water or he-
at-emitting equipment.
The go-e Charger has to be used hanging
vertically or must be mounted vertically in
Electrical protective measures, installation, operation