go-e Gemini flex - Installation Steps 1-4

3030 3131
12. App - settings
Scheduler
The „Scheduler“ option allows you to postpone the
charging process to a time when electricity is avai-
lable in abundance (often at night). In this way, you
act in a particularly sustainable way, as you do not
increase the load peaks that are common at the end
of the working day and take electricity that could ot-
herwise not be used sensibly. In this way, you ensure
grid stability.
After activating the scheduler, you can dene when
the go-e Charger may charge or not charge. For
weekdays, Saturday and Sunday, 2 time periods can
be dened separately.
Combine cheap electricity taris and
photovoltaic surplus charging
In combination with the Controller, you can even
combine charging with PV surplus and favourable
electricity taris in „Eco Mode“ and „Next Trip Mode“.
The Charger rst tries to use as much solar power
as possible and then continues charging with cheap
electricity rates.
For charging with PV surplus power with go-e Char-
ger and go-e Controller, customisations have to be
made in the app under „Settings“ in „ECO Mode“ or
„Next Trip Mode“. There you will nd a slider „Charge
with PV surplus“, which you need to activate. You can
then adjust the exact settings via the link „PV surplus“
below the slider. Here you can also opt for automatic
phase switching in order to be able to charge even
when the PV system‘s output is low. Afterwards, you
need to activate the respective mode in the „Char-
ging“ tab. How charging works in conjunction with
the go-e Controller is explained in detail in its inst-
ructions.
12. App - settings
Photovoltaic surplus charging
Basically, the go-e Charger allows you to charge
your car easily and automatically with surplus elec-
tricity from your photovoltaic system (PV). However,
this requires an energy management system (EMS).
The go-e Controller (separate product) is an exam-
ple of such an EMS . The open interfaces of the go-e
Charger also allow you to use other EMS. For these,
however, you usually need to have programming
knowledge or check in advance whether the EMS you
want to use already has the go-e Charger integrated.
ready integrated. Select the country you live in, your
energy provider and the tari you have signed up for
with your energy provider. Then activate „ECO Mode“
or „Next Trip Mode“ under Mode and set a price, time
or kWh limit at which the go-e Charger should start or
nish charging for the selected charging mode in the
„Settings“ tab.
In „ECO mode“, you can set a price limit per kWh. As
soon as the electricity price falls below the threshold
you set, the wallbox charges your electric car.
In „Next Trip Mode“, you can set a time and a kWh
amount to charge your vehicle without a price limit.
The go-e Charger automatically selects the cheapest
hours for charging according to your electricity tari
until the specied kWh amount is reached within the
set time limit. If you wish, you can continue charging
in ECO mode by manually setting the charging price
limit.
A cloud connection (WiFi) is required for this functio-
nality. The current prices are automatically transfer-
red to the charger and displayed in the „Data“ tab on
the „Charging“ screen.
Installation and operating manual go-e Charger Gemini ex V 1.4Installation and operating manual go-e Charger Gemini ex V 1.4